Shear probes
From Atomix
Welcome to the shear probe group!
The shear probe group addresses best practices in obtaining dissipation rate estimates from shear probes, in a platform independent approach. Our recommendations are applicable for measurements from probes attached to e.g., conventional gravity-driven vertical profilers, gliders, AUVs or autonomous self-propelled floats.
- Flow chart for shear probes
- Benchmark datasets for shear probes
- Anything else?
Flow chart for dissipation estimates using shear probes
The processing of shear-probe data can be divided into the following five major steps and these steps apply to data collected with any platform or vehicle. There are many sub-steps to these major steps. The major steps are;
- Conversion to physical units.
- Determine the speed of profiling of the shear-probe through the water.
- Determine the temperature of the water.
- Convert the shear-probe data samples into physical units
- Convert all other signals per the recommendations of the manufacturer of the sensor or instruments that produce these signals.
- Profile selection.
- Before you can process your shear-probe data to derive the rate of dissipation you must select the segment of data that you wish to process. You must make sure that the selection is meaningful and sensible. For example, the shear probe most must be profiling through the water with a speed, direction, and orientation that is fairly stationary. The selection of data can be partially automated by requiring that the kinematics of your instrument achieve certain minimum criteria. The steps to profile selection are as follows:
- Choose the minimum speed of profiling.
- Choose the direction of the vertical velocity of the profiler.
- Choose the minimum depth.
- Choose the maximum pitch and roll of the profiler.
- Choose the minimum duration over which the minimum speed through maximum pitch and roll must be satisfied.
- Before you can process your shear-probe data to derive the rate of dissipation you must select the segment of data that you wish to process. You must make sure that the selection is meaningful and sensible. For example, the shear probe most must be profiling through the water with a speed, direction, and orientation that is fairly stationary. The selection of data can be partially automated by requiring that the kinematics of your instrument achieve certain minimum criteria. The steps to profile selection are as follows:
- Choosing the processing parameters.
- Dissipation rate estimation.
- Applying quality-control metrics.
