Data processing of raw measurements: Difference between revisions
From Atomix
No edit summary |
No edit summary |
||
| Line 4: | Line 4: | ||
* Remove segments of the time series where there is [[interference from the instrument frame]] | * Remove segments of the time series where there is [[interference from the instrument frame]] | ||
* Determine the noise | * Determine the noise | ||
* Choose how (if?) the missing samples should be replaced | |||
[[Category:Velocity point-measurements]] | [[Category:Velocity point-measurements]] | ||
Revision as of 20:01, 28 October 2021
The following are non-instrument specific recommendations for processing of raw measurements. As such, an initial removal of bad data based on recommendations of the instrument manufacturer should be performed first (e.g. removing data with low coherence). Following that, you must
- Despike the data
- Remove segments of the time series where there is interference from the instrument frame
- Determine the noise
- Choose how (if?) the missing samples should be replaced
