Data processing of raw measurements: Difference between revisions
From Atomix
No edit summary |
mNo edit summary |
||
| Line 1: | Line 1: | ||
{{ADV_processing | |||
|level= | |||
|instrument_type= | |||
}} | |||
The following are specific recommendations for processing raw measurements, which are non-specific to a brand/make of instrument. As such, initial removal of bad data based on recommendations of the instrument manufacturer should be performed first (e.g. removing data with low correlation). Following that, you must: | The following are specific recommendations for processing raw measurements, which are non-specific to a brand/make of instrument. As such, initial removal of bad data based on recommendations of the instrument manufacturer should be performed first (e.g. removing data with low correlation). Following that, you must: | ||
| Line 9: | Line 14: | ||
[[Category:Velocity point-measurements]] | [[Category:Velocity point-measurements]] | ||
---- | |||
Return to [[Velocity_point-measurements|Velocity point-measurements' welcome page]] | |||
Revision as of 14:49, 16 November 2021
The following are specific recommendations for processing raw measurements, which are non-specific to a brand/make of instrument. As such, initial removal of bad data based on recommendations of the instrument manufacturer should be performed first (e.g. removing data with low correlation). Following that, you must:
- Despike the data
- Remove segments of the time series where there is interference from the instrument frame
- Determine the measurement noise levels in the time-domain
